Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Lexus LS 400FACTORY OEM SERVICE PROCEDURE
LS400 A/C Pressure Switch
- Install A/C pressure gauge set. To access pressure switch , remove right headlight. Pressure switch is in-line with A/C receiver. Turn A/C selector switch to OFF position. High side pressure should be 142 psi (10 kg/cm2 ) or less.
- Disconnect switch terminal connector. Using a DVOM, check for continuity between switch terminals No. 2 (ohmmeter positive lead) and No. 3 (ohmmeter negative lead). See Figure-32.
- Turn A/C selector switch to ON position. High side pressure should be 192 psi (13.5 kg/cm2 ) or more. No continuity should exist between switch terminals No. 2 and No. 3. If A/C pressure switch continuity is not correct, replace switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.