Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Lexus LS 400FACTORY OEM SERVICE PROCEDURE
Clearing Codes
- Using SST (part number 09843-18020), connect terminals Tc and E1 of TDCL or check connector. Clear the diagnostic codes stored in ECU by pressing the brake pedal 8 or more times within 3 seconds.
- Check that the TRAC indicator light shows the normal code.
- Remove the SST from the terminals of TDCL or check connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.