Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Lexus LS 400FACTORY OEM SERVICE PROCEDURE
Input Signal Check
- Perform INPUT SIGNAL CHECK under TROUBLE SHOOTING in this article. Check cruise control indicator light while driving vehicle above and below 25 MPH (40 KM/H).
- At speeds below 25 MPH (40 KM/H), indicator light should stay on. At speeds above 25 MPH (40 KM/H), indicator light should blink. If light operates as indicated, go to next inspection item shown on matrix chart in Figure or Figure . If light does not operate as indicated, go to SPEEDOMETER/VEHICLE SPEED (4-PULSE) SIGNAL.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
