Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Code Check/Chart: Notes
Perform diagnostic code check to determine if problem is in sensors or wiring harness. If the normal code is displayed, proceed to MATRIX CHART OF PROBLEM SYMPTOMS. See Figure.
If a malfunction code is present (diagnostic code confirmed), perform procedure indicated by the chart in Figure. See TESTING in this article. If the instructions "go to next inspection item shown on matrix chart" are given in TESTING procedure(s), inspect the next highest numbered item listed.
If the trouble still occurs even though there are no abnormalities in any of the circuits, then check or replace the cruise control ECU as the last step.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
