Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Lexus ES 250 AutomaticFACTORY OEM SERVICE PROCEDURE
Engine Controls - System/Component Tests: Dashpot
- Start and warm engine to operating temperature. Ensure idle speed is 700 RPM. Remove cap, filter and separator from dashpot. Raise and hold engine speed to 2500 RPM.
- Plug small hole in back of dashpot with finger. Release throttle. When throttle is released, engine speed should be 2000 RPM with cooling fan off. After a few seconds, engine should return to idle.
- If dashpot does not function properly, try adjusting using a Hexagon wrench. If dashpot still will not function properly, replace dashpot. When installing separator, filter and cap, install filter with coarse side facing outside.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.