Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Land Rover Range Rover Sport HSTFACTORY OEM SERVICE PROCEDURE
Quick Lookups: Fluids
| FLUID CAPACITIES | |||||||
|---|---|---|---|---|---|---|---|
| Fluid Type | Application | Standard | Metric | Fluid Spec | Note | S/H | |
| Air Cond Compressor Oil | 2 and 3 Zone Climate Control | 2.70 OZS. | 0.07 L | Polyalkylene Glycol SP-A2 | S | ||
| Air Cond Compressor Oil | 4 Zone Climate Control | 4.70 OZS. | 0.13 L | Polyalkylene Glycol SP-A2 | S | ||
| Air Cond Refrigerant | Gas/Electric | 2 and 3 Zone Climate Control | 2.10 LBS. | 0.95 KG | R-1234yf | S | |
| Brake Fluid | N/A | N/A | LAND ROVER Brake Fluid | It is recommended to use Land Rover brake fluid. If unavailable, then a non-petroleum based brake fluid meeting specification DOT4 ISO 4925 Class 6 may be used. | S | ||
| Diesel Exhaust Fluid | 4.75 GALS. | 17.98 L | AdBlue, Aus 32 and Arla 32 Meeting: ISO 22241 and ISO 22241-1 | S | |||
| Engine Oil | 3.0L Eng,Gas/Electric | w/Filter | 9.30 QTS. | 8.8 L | SAE 0W-20 meeting specs ST JLR.03.5006 | S | |
| Windshield Washer Fluid | 6.65 QTS. | 6.29 L | Windshield Wash with Frost Protection | Follow the Manufacturer's Instructions for the mixture ratio. Capacities are approximate and provided as a guide only. All oil levels must be checked using the dipstick, level plugs or driver information module, as applicable. | S | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.