2021 Land Rover Defender 110FACTORY OEM SERVICE PROCEDURE

Replacement Module Routine Must Be Run When Replacing Any Modules (SSM76100)

Publication date: 2023-10-09
Reference number: SSM76100

REPLACEMENT MODULE ROUTINE MUST BE RUN WHEN REPLACING ANY MODULES

REPLACEMENT MODULE ROUTINE MUST BE RUN WHEN REPLACING ANY MODULES

TECHNICAL SERVICE BULLETIN

Reference Number(s): SSM76100, Date of Issue:  October 09, 2023
LAND ROVER: Defender/L663; Discovery/L462; Discovery Sport/L550; New Range Rover/L460; New Range Rover Evoque/L551; New Range Rover Sport/L461; Range Rover Velar/L560
SERVICE CATEGORY: Diagnostic Software Hardware

SITUATION

JLR Engineering investigations have found that, in some instances, software updates and configurations have not been completed after new headlamps, Electric Power Assisted Steering (EPAS) gears or electrical modules are installed.

Although the new parts will function without the replacement module routine being run, they will not be configured to the vehicle or at the correct software level.

ACTION

Follow the instruction(s) below.

SERVICE INFORMATION

When a replacement electrical module is installed, the replace module routine MUST  be run by following the process in TOPIx Cloud.

  1. Open 'Diagnostics' tab in TOPIx Cloud
  2. Select the module to be updated from 'Vehicle Data' module list in LH column
  3. Select 'Module Programming' in RH column, within the 'Applications and Troubleshooting' list
  4. Select and run the applicable 'Replace Module' routine

(Ref 000001160)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.