2021 Land Rover Defender 110FACTORY OEM SERVICE PROCEDURE

Image Processing Module 'A' (IPMA), Cannot Be Updated Using Pathfinder 314 (SSM75243)

Publication date: 2021-07-29
Reference number: SSM75243

IMAGE PROCESSING MODULE 'A' (IPMA), CANNOT BE UPDATED USING PATHFINDER 314

IMAGE PROCESSING MODULE 'A' (IPMA), CANNOT BE UPDATED USING PATHFINDER 314

TECHNICAL SERVICE BULLETIN

Reference Number(s): SSM75243, Date of Issue:  July 29, 2021
LAND ROVER: Defender/L663
SERVICE CATEGORY: Diagnostic Software Hardware
SYMPTOM: 000101 Diagnostic Concerns

CONTENT

ISSUE

When attempting to complete the "Update ECU  " for the Image Processing module 'A' [IPMA], the process fails to complete with error message "Request Out Of Range  ".

CAUSE

When a previous software update has failed, leaving the module without any software part loaded, the module will require to download the software In two stages.

PERMANENT CORRECTIVE ACTION

This concern has been resolved with the release of PATHFINDER version 340  . The manual patch will no longer be available to download and this SSM will be deleted in 7 days.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.