2021 Land Rover Defender 110FACTORY OEM SERVICE PROCEDURE

Engine Health Check Application (SSM76305)

Publication date: 2025-04-13
Reference number: SSM76305

ENGINE HEALTH CHECK APPLICATION

ENGINE HEALTH CHECK APPLICATION

TECHNICAL SERVICE BULLETIN

Reference Number(s): SSM76305, Date of Issue:  April 17, 2025
LAND ROVER: Defender/L663; Discovery/L462; Discovery Sport/L550; New Range Rover/L460; New Range Rover Evoque/L551; New Range Rover Sport/L461; Range Rover/L405; Range Rover Evoque/L538; Range Rover Sport/L494; Range Rover Velar/L560
SERVICE CATEGORY: Diagnostic Software Hardware

CONTENT

Model/Model Year/Derivative 

Range Rover Sport (L494)/20-22MY/AJ20P4/AJ20P6

Range Rover Sport (L461)/23MY onwards/AJ20P6

Range Rover (L405)/20-22MY/AJ20P4/AJ20P6

Range Rover (L460)/22MY onwards/AJ20P6

Range Rover Evoque (L538)/16-19MY/AJ20D4/AJ20P4

Range Rover Evoque (L551)/20MY onwards/AJ20D4/AJ20P4/AJ21D4

Discovery Sport (L550)/15MY onwards/AJ20D4/AJ20P4/AJ21D4

Defender (L663)/20MY Onwards/AJ20D4/AJ20P4/AJ20P6/AJ21D4

Discovery (L462)/17MY Onwards/AJ20D4/AJ20P4/AJ20P6/AJ21D4

SITUATION

Jaguar Land Rover (JLR) has launched a new engine health check application available in TOPIx Cloudand SDD to assist technicians with engine diagnostics.

ACTION

Please refer to the service information below.

SERVICE INFORMATION

This application should be used to address any powertrain-related running issues. Follow these instructions to access the health check:

  • Connect the approved JLR Battery Support Unit (BSU).
  • Connect the approved JLR diagnostic equipment.
  • Select "Fault and Breakdown" and start a new workflow (the same symptoms apply if using SDD).

Enter one of the following symptoms:

  • Powertrain > Engine > Engine Performance > Poor Engine Performance

SDD Engine Health Check Features 

Features Covered:

  • Fuel Balance Correction Values: Read within engine health checks.
  • SDD: Reset for Fuel Injectors Learning.

Engine Testing:

  • Engine running and non-running Applications.
  • Non-running test provides data on oil pressure, timing chain status, and compression test results.

PCM DTCs:

  • Captures Pending DTCs and Permanent DTCs within the health check.

TOPIx Cloud Engine Health Check Features 

Engine Testing:

  • Engine running and non-running Applications.
  • Non-running test provides data on oil pressure and compression test results.

PCM DTCs:

  • Captures Pending DTCs and Permanent DTCs within the health check.

Additional Instructions for Both SDD and TOPIx: 

  • Apply IDU Firmware Update v1 if necessary for IDU2 functionality.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.