Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Land Rover Defender 110FACTORY OEM SERVICE PROCEDURE
DTC U3000-44: Control Module - Data memory failure: Action
- Using the Jaguar Land Rover approved diagnostic equipment, reconfigure the image processing module with the latest level software. Clear the Diagnostic Trouble Code(s), road test the vehicle and check if the DTC has set
- If the fault persists, install a new image processing module
- If a new image processing module A is installed, using the Jaguar Land Rover approved diagnostic equipment, run the routine - Replace ECU
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.