Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Land Rover Defender 110FACTORY OEM SERVICE PROCEDURE
DTC U3000-05: Control Module - System programing failures: Action
NOTE:
This DTC does not represent a fault and is triggered by routine diagnostic activity when the air suspension is requested to operate in tight tolerance mode
- Connect a Jaguar Land Rover approved Midtronics battery power supply to the vehicle startup battery
- Connect the Jaguar Land Rover approved diagnostic equipment to the vehicle and begin a new session. The diagnostic equipment will detect the correct Vehicle Identification Number (VIN) for the current vehicle and automatically take the vehicle out of transit mode if required
- Following all the on-screen instructions, select 'ECU Diagnostics'; then, select 'Chassis Control Module [CHCM]'; then, select 'ECU Functions'; then, select 'Suspension geometry set-up' and, when prompted, select 'Normal Mode'. Continue to follow all the on-screen instructions until the application completes successfully. Finally, exit the current diagnostic session
- Disconnect the diagnostic equipment and battery power supply from the vehicle. Clear the DTCs and retest to confirm the DTC is no longer present and any warning messages that may have been displayed on the instrument cluster are no longer showing
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
