Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Standard Speed Limiter
The speed Limiter warning indicator will illuminate when the speed limiter feature has been selected. The system speed is set using the speed control 'SET +' and '-' switches. The selected speed is displayed in the Instrument Cluster (IC). The set speed can be adjusted at any time using the speed control 'SET+' or '-' switches. ASL can be suspended by operating the 'CANCEL' switch.
Speed limiter function can be resumed by operating the 'RES' switch, when:
- The vehicle speed is at the previously set speed limiter speed.
- The vehicle speed is up to a maximum of 30 km/h (19 mph) above the previous set speed.
If the vehicle speed is too high to resume speed limiter operation, a message will be displayed in the IC.
The speed limiter system allows full driver control of the vehicle speed up to the set speed. The speed limiter will restrict the vehicle speed and will not allow the speed to go over the set limit. If the driver is fully depressing the accelerator pedal, ASL will be temporarily overridden.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
