Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2015 Land Rover Range Rover BaseFACTORY OEM SERVICE PROCEDURE
DTC U3000-54: Control Module - Missing calibration: Action
NOTE:
The following pre-conditions are required to run the routine correctly: ignition is switched on, the occupancy seat module has gone through the seat assembly plant calibration, no collision event received from the restraints control module during the current ignition cycle, no faults present in the current ignition cycle, occupancy seat module has settled for 10 seconds, temperature is between 6° C (42°F) and 36°C (97°F), seat is bolted in original installation position
- Using the manufacturer approved diagnostic system, perform routine - Learn Seat Occupant Classification Zero Position (5007)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.