Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Index DTC: Multi-Function Display (MFD) -- LR2/L359
- Diagnostic Trouble Code Index DTC: Multi-Function Display (MFD)
- Description And Operation
- Multi-Function Display (MFD)
- DTC B108E-01: Display - General electrical failure
- DTC B10BD-11: Multifunctional Switch - Circuit short to ground
- DTC B10BD-13: Multifunctional Switch - Circuit open
- DTC B10BD-23: Multifunctional Switch - Activation too long - Signal stuck low
- DTC U0010-88: Medium Speed CAN Communication Bus - BMS Bus Off - Bus off
- DTC U0074-88: Control Module Communication Bus "B" Off - Bus off
- DTC U0184-00: Lost Communication With Radio - No sub type information
- DTC U0195-00: Lost Communication With Subscription Entertainment Receiver Module - No sub type information
- DTC U0422-68: Invalid Data Received From Body Control Module (BCM) - Event information
- DTC U2100-00: Initial Configuration Not Complete - No sub type information
- DTC U2101-00: Control Module Configuration Incompatible - No sub type information
- DTC U3000-00: Control Module - No sub type information
- DTC U3006-16: Control Module Input Power "A" - Circuit voltage below threshold
- DTC U3006-17: Control Module Input Power "A" - Circuit voltage above threshold
- Description And Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.