Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Index DTC: Keyless Vehicle Module (KVM) -- LR2/L359
- Diagnostic Trouble Code Index DTC: Keyless Vehicle Module (KVM)
- Description And Operation
- Keyless Vehicle Module (KVM)
- DTC B102B-00: Passive Key - No sub type information
- DTC B10A9-00: Remote Keyless Entry Less Than 2 Keys Programmed - No sub type information
- DTC B10C7-00: Interior Trunk Antenna - No sub type information
- DTC B10C7-11: Interior Trunk Antenna - Circuit short to ground
- DTC B10C7-12: Interior Trunk Antenna - Circuit short to battery
- DTC B10C7-13: Interior Trunk Antenna - Circuit open
- DTC B10C8-00: Interior Center Antenna - No sub type information
- DTC B10C8-11: Interior Center Antenna - Circuit short to ground
- DTC B10C8-12: Interior Center Antenna - Circuit short to battery
- DTC B10C8-13: Interior Center Antenna - Circuit open
- DTC B10C9-00: Interior Front Antenna - No sub type information
- DTC B10C9-11: Interior Front Antenna - Circuit short to ground
- DTC B10C9-12: Interior Front Antenna - Circuit short to battery
- DTC B10C9-13: Interior Front Antenna - Circuit open
- DTC B12EA-96: Radio Frequency (RF) Receiver - Component internal failure
- DTC B1335-00: Front Triangulation/Loadspace Antenna - No sub type information
- DTC B1335-11: Front Triangulation/Loadspace Antenna - Circuit short to ground
- DTC B1335-12: Front Triangulation/Loadspace Antenna - Circuit short to battery
- DTC B1335-13: Front Triangulation/Loadspace Antenna - Circuit open
- DTC B133D-00: Loadspace/Interior Boot Antenna - No sub type information
- DTC B133D-11: Loadspace/Interior Boot Antenna - Circuit short to ground
- DTC B133D-12: Loadspace/Interior Boot Antenna - Circuit short to battery
- DTC B133D-13: Loadspace/Interior Boot Antenna - Circuit open
- DTC U0010-88: Medium Speed CAN Communication Bus - Bus off
- DTC U0300-00: Internal Control Module Software Incompatibility - No sub type information
- DTC U201F-00: External Receiver - No sub type information
- DTC U201F-31: External Receiver - No signal
- DTC U201F-95: External Receiver - Incorrect assembly
- DTC U2100-00: Initial Configuration Not Complete - No sub type information
- DTC U2101-00: Control Module Configuration Incompatible - No sub type information
- DTC U3000-49: Control Module - Internal electronic failure
- DTC U3002-81: Vehicle Identification Number - Invalid serial data received
- Description And Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.