Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2014 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Index DTC: Headlamp Leveling Control Module (HLCM) -- LR2/L359
- Diagnostic Trouble Code Index DTC: Headlamp Leveling Control Module (HLCM)
- Description And Operation
- Headlamp Leveling Control Module (HLCM)
- DTC B1041-04: Leveling Control - System internal failures
- DTC B1041-54: Leveling Control - Missing calibration
- DTC B10AE-11: Headlamp Leveling Motor - Circuit short to ground
- DTC B10AE-12: Headlamp Leveling Motor - Circuit short to battery
- DTC B10AE-64: Headlamp Leveling Motor - Signal plausibility failure
- DTC B1A59-11: Sensor 5 Volt Supply - Circuit short to ground
- DTC B1A59-12: Sensor 5 Volt Supply - General electrical failure
- DTC C1A03-12: Left Front Height Sensor - Circuit short to battery
- DTC C1A03-14: Left Front Height Sensor - Circuit short to ground or open
- DTC C1A05-12: Left Rear Height Sensor - Circuit short to battery
- DTC C1A05-14: Left Rear Height Sensor - Circuit short to ground or open
- DTC U0001-88: High Speed CAN Communication Bus - Bus off
- DTC U0100-00: Lost Communication With ECM/PCM "A" - No sub type information
- DTC U0101-00: Lost Communication With TCM - No sub type information
- DTC U0102-00: Lost Communication With Transfer Case Control Module - No sub type information
- DTC U0121-00: Lost Communication With Anti-lock Brake System (ABS) Control Module - No sub type information
- DTC U0126-00: Lost Communication With Steering Angle Sensor Module - No sub type information
- DTC U0140-00: Lost Communication With Body Control Module - No sub type information No sub type information
- DTC U0300-00: Internal Control Module Software Incompatibility -
- DTC U0402-00: Invalid Data Received From Transmission Control Module - No sub type information
- DTC U0403-00: Invalid Data Received From Transfer Case Control Module - No sub type information
- DTC U0415-00: Invalid Data Received From Anti-Lock Brake System (ABS) Control Module - No sub type information
- DTC U0422-00: Invalid Data From Body Control Module - No sub type information
- DTC U0428-00: Invalid Data Received From Steering Angle Sensor Module - No sub type information
- DTC U2100-00: Initial Configuration Not Complete - No sub type information
- DTC U2101-00: Control Module Configuration Incompatible - No sub type information
- DTC U3002-81: Vehicle Identification Number - Invalid serial data received
- DTC U3003-16: Battery Voltage - Circuit voltage below threshold
- DTC U3003-17: Battery Voltage - Circuit voltage above threshold
- DTC U3003-62: Battery Voltage - Signal compare failure
- Description And Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
