2014 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE

Removal And Installation: Removal

CAUTION:
  • Extreme cleanliness must be exercised when handling these components.
  • If brake fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

All vehicles

  1. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  2. Disconnect the battery ground cable.

    Refer to: BATTERY DISCONNECT/CONNECT .

  3. Remove the battery tray.

    Refer to: Battery Tray .

    Right-hand drive vehicles

  4. Remove the plenum chamber panel.

    Left-hand drive vehicles

  5. Remove the windshield wiper motor and linkage.

    Refer to: Windshield Wiper Motor .

  6. CAUTION: Make sure that all openings are sealed.
    G11589547

    All vehicles

  7. G11589516
  8. G11589549
  9. G11589550

    Left-hand drive vehicles

  10. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed.
    G11589551

    Right-hand drive vehicles

  11. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed.
    G11589552

    All vehicles

  12. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed.
    G11589553
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.