Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal And Installation: Installation
All vehicles
- Install the ABS module.
Torque Specification: 10 Nm
- Install the brake fluid tubes.
Torque Specification: 15 Nm
- Install the battery tray support.
Torque Specifications:
M6 10 Nm
M8 25 Nm
Left-hand drive vehicles
- Connect the brake booster vacuum line.
All vehicles
- Install the ECM.
- Secure the vacuum line and harness.
Left-hand drive vehicles
- Install the windshield wiper motor and linkage.
Refer to: Windshield Wiper Motor .
Right-hand drive vehicles
- Install the plenum chamber panel.
All vehicles
- Install the battery tray.
Refer to: Battery Tray .
- Connect the battery ground cable.
Refer to: BATTERY DISCONNECT/CONNECT .
- Bleed the brake system.
Refer to: Brake System Bleeding .
-
If a new component has been installed, configure using Land Rover approved diagnostic equipment.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.