2013 Land Rover Range Rover BaseFACTORY OEM SERVICE PROCEDURE

DTC U3000-45: Control Module - Program memory failure: Action

  • Refer to the appropriate system wiring diagram and check the power and ground circuits to the module for circuit faults, including intermittent high resistance. Repair circuit as required, clear the DTCs and retest
  • If the fault persists, check the operation of the alternator and replace
  • Check for power-related DTCs and refer to the relevant DTC index
  • If the fault persists, install a new dynamic response control module
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.