Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Land Rover LR4 BaseFACTORY OEM SERVICE PROCEDURE
Steering Column: Installation
- Note the potentiometer hexadecimal code on the new steering column label for future reference.
- Install the steering angle sensor.
- Tighten the Torx screws to 3 Nm (2.2 lb.ft).
Vehicles with electric steering columnÂ
CAUTION:
The potentiometer adjustment values are unique for each steering column. Failure to enter the correct code during calibration may result in damage to the vehicle.
All vehiclesÂ
CAUTION:
Make sure the bolt holes are clean and free of swarf.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.