Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE

Component Locations - LR2

Select a section or procedure below to view factory instructions:

Accessory Drive Antenna Anti-Lock Control - Stability Assist Anti-Theft - Active Anti-Theft - Passive Automatic Transmission/Transaxle Automatic Transmission/Transaxle External Controls Battery, Mounting And Cables Brake System General Information Climate Control System Driveshaft Electronic Engine Controls Engine Cooling Engine Emission Control Engine Ignition Evaporative Emissions Exhaust System Exterior Lighting Front Disc Brake Front Drive HALFSHAFTS Front Suspension Fuel Charging And Controls Fuel Tank And Lines Generator And Regulator Glass, Frames And Mechanisms Handles, Locks, Latches And Entry Systems Horn Hydraulic Brake Actuation Information And Entertainment System Information And Message Center Instrument Cluster Instrument Panel And Console Intake Air Distribution And Filtering Interior Lighting MULTIFUNCTION Electronic Modules Parking Aid Parking Brake And Actuation Power Brake Actuation Power Steering Rear Disc Brake Rear Drive Axle/Differential Rear Drive HALFSHAFTS Rear Suspension Rear View Mirrors Ride And Handling Optimization Roof Opening Panel Safety Belt System Seating Speed Control Starting System Steering Column Steering Column Switches Steering Linkage Supplemental Restraint System Transmission/Transaxle Cooling

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.