Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE
Section 545 (Diagnostic Trouble Code Index DTC: Occupant Classification Sensor Control Module (OCSCCM) -- LR2/L359)
WARNING: This page is about a different car, the 2015 Land Rover LR2, 2014 Land Rover LR2, and 2013 Land Rover LR2. However, it is still accessible from the selected car via links, so may be relevant.
- Diagnostic Trouble Code Index DTC: Occupant Classification Sensor Control Module (OCSCCM)
- Description And Operation
- Occupant Classification Sensor Control Module (OCSCM)
- DTC B1193-53: Crash Event Storage Full and Locked - Deactivated
- DTC B1A54-01: Occupant Belt Tension Sensor - General electrical failure
- DTC B1A54-02: Occupant Belt Tension Sensor - General signal failure
- DTC B1A54-11: Occupant Belt Tension Sensor - Circuit short to ground
- DTC B1A54-12: Occupant Belt Tension Sensor - Circuit short to battery
- DTC B1A54-13: Occupant Belt Tension Sensor - Circuit open
- DTC B1A62-02: Pressure Sensor - General signal failure
- DTC B1A62-11: Pressure Sensor - Circuit short to ground
- DTC B1A62-12: Pressure Sensor - Circuit short to battery
- DTC B1A62-13: Pressure Sensor - Circuit open
- DTC B1A62-7B: Pressure Sensor - Low fluid level
- DTC U0001-88: High Speed CAN Communication Bus - Bus off
- DTC U0151-00: Lost Communication With Restraints Control Module - No sub type information
- DTC U0300-00: Internal Control Module Software Incompatibility - No sub type information
- DTC U2016-51: Control Module Main Software - Not programmed
- DTC U201A-51: Control Module Main Calibration Data - Not programmed
- DTC U3000-04: Control Module - System internal failures
- DTC U3000-54: Control Module - Missing calibration
- DTC U3003-16: Battery Voltage - Circuit voltage below threshold
- DTC U3003-17: Battery Voltage - Circuit voltage above threshold
- Description And Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.