Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE
Front Disc Brake: Specifications
WARNING: This page is about a different car, the 2013 Land Rover LR4, 2012 Land Rover LR4, 2011 Land Rover LR4, and 2010 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Specification |
| Disc type | Ventilated |
| Disc diameter: | |
| Vehicles with 4.0L or 2.7L diesel engine | 317 mm (12.6 in) |
| Vehicles with 5.0L or 3.0L diesel engine | 360 mm (14.2 in) |
| Disc thickness: | |
| New | 30.0 mm (1.18 in) |
| Service limit | 27.0 mm (1.063 in) |
| Maximum disc run-out - disc installed | 0.05 mm (0.002 in) |
| Caliper type | Sliding pin, twin piston |
| Piston diameter | 48.0 mm (1.8 in) |
| Pad minimum thickness | 3.0 mm (0.12 in) |
| Brake pad wear warning lead: | |
| Location | Front left hand brake pad |
| Activates at | 75% of pad life utilised |
Torque Specifications
| Description | Nm | lb-ft |
|---|---|---|
| Brake caliper bleed screw | 10 | 7 |
| Brake disc Torx screw | 16 | 12 |
| Brake caliper anchor plate bolts | 275 | 202 |
| Brake caliper housing bolts | 35 | 26 |
| Brake hose union | 32 | 24 |
| Brake hose retaining bracket to wheel knuckle bolt | 22 | 16 |
| Road wheel nuts | 140 | 103 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.