Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Land Rover LR2 BaseFACTORY OEM SERVICE PROCEDURE
Section 110 (Seating)
WARNING: This page is about a different car, the 2012 Land Rover Range Rover Sport and 2011 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
- Seating
- Specifications
- Diagnostic Procedures
- Removal And Installation
- Rear Seat
- Front Seat
- Front Seat Track Motor
- Front Seat Recliner Motor
- Front Seat Cushion Cover
- Front Seat Cushion Heater Mat
- Rear Seat Cushion Cover (Vehicles With: 60/40 Split Seat)
- Front Seat Height Adjustment Motor
- Front Seat Backrest Cover
- Rear Seat Backrest Cover (Vehicles With: 60/40 Split Seat)
- Front Seat Cushion
- Seat Track (Vehicles With: Power Seats)
- Front Seat Manual Height Adjustment Lever
- Front Seat Armrest
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
