2012 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE

Ignition Switch: Service and Repair





Ignition Switch
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal
1 Make the SRS system safe.
For additional information, refer to Standard Workshop Practices Standard Workshop Practices
2 Remove the driver lower air bag module.
For additional information, refer to Driver Lower Air Bag Module Driver Lower Air Bag Module

Factory service manual diagram




NOTE:
RHD illustration shown, LHD is similar.
3 Remove the keyless start control module trim cover.

Factory service manual diagram



4 Remove the steering column lower cowl.
5 Adjust the steering column to its lowest position.

Factory service manual diagram




Factory service manual diagram




NOTE:
Take extra care when releasing the clips.
6 Remove the instrument cluster surround.

Factory service manual diagram



7 Remove the ignition switch.

Installation
1 To install, reverse the removal procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.