2012 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE

Engine Oil: Service and Repair






Engine Oil Draining and Filling

NOTE:
Removal steps in this procedure may contain installation details.

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.
2 Remove the oil filter.
For additional information, refer to Oil Filter Element Service and Repair
3 Remove the engine undershield.
For additional information, refer to Engine Undershield Engine Undershield

Factory service manual diagram




WARNING: Avoid skin contact with the specified material.

CAUTION: Hot fluid.

CAUTION: Be prepared to collect escaping fluids.

Torque to: 38 Nm
Remove and discard the sealing washer.

CAUTION: Make sure that the component is clean, free of foreign material and lubricant.

CAUTION: Make sure that new sealing washers are installed.
4 To install, reverse the removal procedure.
5 Check and top-up the engine oil.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.