Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Land Rover LR4 HSEFACTORY OEM SERVICE PROCEDURE
Anti-Lock Control - Traction Control: Specifications
General SpecificationÂ
| Item | Specification |
| System make/type | Bosch 8.0 Anti-lock braking system with Electronic Brake Distribution (EBD), Corner Brake Control (CBC), Electronic Traction Control (ETC), Hill Descent Control (HDC), Anti-roll Mitigation (ARM), Emergency Brake Assist (EBA), and Dynamic Stability Control (DSC) |
| Wheel speed sensors:Â | Â |
| Make/type | Bosch DF11i |
| Location | Front and rear knuckles with the active directional sensor acting on the driveshaft pole wheel |
| Yaw rate sensor make/type | Bosch DRS MM1.OR |
Torque SpecificationsÂ
| Description | Nm | lb-ft |
|---|---|---|
| Front road wheel speed sensor bolt | 9 | 7 |
| Front brake caliper anchor plate bolts | 275 | 203 |
| Front brake caliper housing bolts | 32 | 24 |
| Front brake hose retaining bracket to wheel knuckle bolt | 25 | 18 |
| Rear road wheel speed sensor to wheel knuckle bolt | 9 | 7 |
| ABS module mounting bracket nuts | 8 | 6 |
| ABS module to mounting bracket nuts | 23 | 17 |
| M10 Brake tube union nuts | 15 | 11 |
| M12 Brake tube union nuts | 15 | 11 |
| M14 Brake tube union nut | 17 | 13 |
| Yaw rate sensor bolts | 7 | 5 |
| Road wheel nuts | 140 | 103 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
