Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Anti-Lock Brake System (Abs) Module: Installation
- Install the ABS module.
Torque: 10 Nm
- Install the brake fluid tubes.
Torque: 15 Nm
- Install the battery tray support.
Torques:
M6: 10 Nm
M8: 25 Nm
- Connect the brake booster vacuum line.
- Install the ECM.
- Secure the vacuum line and harness.
- Install the windshield wiper motor and linkage. Refer to WINDSHIELD WIPER MOTOR .
- Install the plenum chamber panel.
- Install the battery tray. Refer to BATTERY TRAY .
- Connect the battery ground cable. Refer to SPECIFICATIONS .
- Bleed the brake system. Refer to BRAKE SYSTEM BLEEDING .
- If a new component has been installed, configure using Land Rover approved diagnostic equipment.
All Vehicles
Left-Hand Drive Vehicles
All Vehicles
Left-Hand Drive Vehicles
Right-Hand Drive Vehicles
All Vehicles
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.