Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE
Control Module: Service and Repair
Transmission Control Module (TCM) - 3.2L
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the cover and disconnect the battery ground cable.
3. Remove the A/C compressor mounting bracket.
4. Release and disconnect the selector lever cable.

5. Release the support bracket.

6. Remove the transmission selector lever.

7.

Installation
1. Install the TCM.
Torque:
24 Nm
2. Install the transmission selector lever.
Torque:
13 Nm
3. Secure and connect the selector lever cable.
4. Install the support bracket.
Torque:
25 Nm
5. Install the A/C compressor mounting bracket.
6. Connect the battery ground cable and install the cover.
7. If a new component has been installed, configure using Land Rover approved diagnostic equipment.
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the cover and disconnect the battery ground cable.
3. Remove the A/C compressor mounting bracket.
4. Release and disconnect the selector lever cable.
5. Release the support bracket.
6. Remove the transmission selector lever.
7.
Installation
1. Install the TCM.
Torque:
24 Nm
2. Install the transmission selector lever.
Torque:
13 Nm
3. Secure and connect the selector lever cable.
4. Install the support bracket.
Torque:
25 Nm
5. Install the A/C compressor mounting bracket.
6. Connect the battery ground cable and install the cover.
7. If a new component has been installed, configure using Land Rover approved diagnostic equipment.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
