2009 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE

Torque Specifications

Torque Specifciations

Axle Mounting Bracket Bolts 24 Nm (18 ft. lbs.)
Oil Drain Plug 35 Nm (26 ft. lbs.)
Oil Filler Plug 35 Nm (26 ft. lbs.)
Pinion Nut 48 Nm (35 ft. lbs.)
Power Transfer Unit Front Mounting Bracket Heat Shield 10 Nm (7 ft. lbs.)
Power Transfer Unit Bracket to Engine Block Bolts 65 Nm (48 ft. lbs.)
Power Transfer Unit Bracket to Power Transfer Unit Bolts 65 Nm (48 ft. lbs.)
Power Transfer Unit to Transmission Housing Bolts 65 Nm (48 ft. lbs.)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.