Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE
Torque Specifications
Torque Specifications
High-Pressure Line to Power Steering Pump 25 Nm (18 ft. lbs.)
Power Steering Fluid Cooler 10 Nm (7 ft. lbs.)
Power Steering Fluid Line Bolts 27 Nm (20 ft. lbs.)
Power Steering Fluid Pressure Lines 25 Nm (18 ft. lbs.)
Power Steering Gear to Cross Member Nuts 105 Nm (77 ft. lbs.)
Power Steering Pump Bolts 25 Nm (18 ft. lbs.)
High-Pressure Line to Power Steering Pump 25 Nm (18 ft. lbs.)
Power Steering Fluid Cooler 10 Nm (7 ft. lbs.)
Power Steering Fluid Line Bolts 27 Nm (20 ft. lbs.)
Power Steering Fluid Pressure Lines 25 Nm (18 ft. lbs.)
Power Steering Gear to Cross Member Nuts 105 Nm (77 ft. lbs.)
Power Steering Pump Bolts 25 Nm (18 ft. lbs.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
