2009 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE

Torque Specifications

Torque Specifications

Catalytic Monitor Sensor 45 Nm (33 ft. lbs.)
Catalytic Converter to Exhaust Manifold Bolts* 30 Nm (22 ft. lbs.)
Catalytic Converter to Center Muffler Nut and Retaing Clamps 24 Nm (18 ft. lbs.)
Exhaust Manifold Bolts 24 Nm (18 ft. lbs.)
Exhaust Manifold Heatshield Bolts 10 Nm (7 ft. lbs.)
Exhaust Support Brackets to Front Subframe/Floor Bolts 24 Nm (18 ft. lbs.)
Exhaust Support Bracket to Center Bearing Carrier Bolts 24 Nm (18 ft. lbs.)
Exhaust Tail Pipe Trim Screws 3 Nm (2 ft. lbs.)
Front Muffler Service Sleeve Clamp Nuts 40 Nm (28 ft. lbs.)
Heated Oxygen Sensor (HO2S)** 45 Nm (33 ft. lbs.)
*It is not appropriate to either fit or remove these fixings using air tools due to risk of cold welding/snapping.
**Apply anti-seize lubricants to threads of sensor
-Refer to procedures for correct torque sequences
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.