Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE
Intake Manifold
Intake Manifold


The intake manifold attaches to the cylinder head with 6 bolts and the oil pan with 2 bolts.
Intake manifold bolts 16 Nm (12 lb-ft)
Lower inlet manifold bolts 10 Nm (7 lb-ft)
Throttle body
Install the throttle body and tighten the screws in the sequence shown.
Torque: 8 Nm (6 lb-ft)

Throttle body to block support bolt 10 Nm (7 lb-ft)
* New nuts/bolts must be fitted A = refer to procedure for correct torque sequence
The intake manifold attaches to the cylinder head with 6 bolts and the oil pan with 2 bolts.
Intake manifold bolts 16 Nm (12 lb-ft)
Lower inlet manifold bolts 10 Nm (7 lb-ft)
Throttle body
Install the throttle body and tighten the screws in the sequence shown.
Torque: 8 Nm (6 lb-ft)
Throttle body to block support bolt 10 Nm (7 lb-ft)
* New nuts/bolts must be fitted A = refer to procedure for correct torque sequence
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
