Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE
G862187T13 : Check For Installation of Navigation Module
Pinpoint Tests
NOTE: Visually inspect for any of the following conditions and rectify any fault identified prior to carrying out any tests on the MOST Network.
^ Any sharp bends in the optical fibre harness (check for this before disturbing any module or connector).
^ Incorrect engagement of any optical connectors
^ Incorrect engagement of any electrical connectors
^ Damage to the optical fibre harness (chafing, abrasion, kinking, cuts, break, etc)
^ Incorrect assembly of the optical network
^ Unless otherwise stated, ensure vehicle ignition status is set to 'ON' when carrying out MOST Network tests.
G862187t13 : CHECK FOR INSTALLATION OF NAVIGATION MODULE
1. Check for installation of Navigation module.
^ Is there a Navigation module installed to vehicle?
->Yes
GO to Pinpoint Test G862187t14.G862187T14 : Check For Failure of Optical Fibre to Navigation Module
->No
GO to Pinpoint Test G862187t16.G862187T16 : Check For Failure of Optical Fibre to Audio Amplifier Module
NOTE: Visually inspect for any of the following conditions and rectify any fault identified prior to carrying out any tests on the MOST Network.
^ Any sharp bends in the optical fibre harness (check for this before disturbing any module or connector).
^ Incorrect engagement of any optical connectors
^ Incorrect engagement of any electrical connectors
^ Damage to the optical fibre harness (chafing, abrasion, kinking, cuts, break, etc)
^ Incorrect assembly of the optical network
^ Unless otherwise stated, ensure vehicle ignition status is set to 'ON' when carrying out MOST Network tests.
G862187t13 : CHECK FOR INSTALLATION OF NAVIGATION MODULE
1. Check for installation of Navigation module.
^ Is there a Navigation module installed to vehicle?
->Yes
GO to Pinpoint Test G862187t14.G862187T14 : Check For Failure of Optical Fibre to Navigation Module
->No
GO to Pinpoint Test G862187t16.G862187T16 : Check For Failure of Optical Fibre to Audio Amplifier Module
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
