2009 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE

Mechanical Specifications


Torque Specifications

Camshaft Position (CMP) Sensor Bolt* 10 Nm (7 ft. lbs.)
Catalyst Monitor Sensor 45 Nm (33 ft. lbs.)
Cataylst Monitor Sensor Harness Bolts 6 Nm (5 ft. lbs.)
Crankshaft Position (CKP) Sensor Torx Bolts 10 Nm (7 ft. lbs.)
Engine Control Module (ECM) Bracket Bolts 6 Nm (4 ft. lbs.)
Flywheel Sensor Bolt 10 Nm (7 ft. lbs.)
Flywheel Sensor Bracket Screws 10 Nm (7 ft. lbs.)
Fuel Rail Pressure Sensor 6 Nm (5 ft. lbs.)
Heated Oxygen Sensor (HO2S)** 45 Nm (33 ft. lbs.)
Knock Sensor Retaining Bolt 20 Nm (14 ft. lbs.)
Mass Air Flow (MAF) Sensor Torx Screws 2 Nm (1 ft. lbs.)
*Apply CLEAN engine oil to a new CMP Sensor O-ring
**Apply anti-seize lubricant to threads of sensor
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.