2009 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE

Catalyst Monitor Sensor



Catalyst Monitor Sensor

Service Repair No - 19.22.71


Special Service Tools

Factory service manual diagram




310-121
Wrench, H02S

Removal

WARNING: Make sure to support the vehicle with axle stands.

1. Raise the vehicle on a lift.
2. Torque: 6 Nm
3. Torque: 45 Nm

Factory service manual diagram




Installation
1. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.