Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE
Alignment: Service and Repair
Four-Wheel Alignment
1. Check the geometry specifications.
2. Check the tie rod ends, suspension joints, wheel bearings and wheels and tires for damage, wear and free play.
3. Check and adjust tire pressures.
4. Position the vehicle on a calibrated, level, vehicle lift.
5. Release the vehicle parking brake.
6. Using only four wheel alignment equipment approved by Land Rover, check and adjust the wheel alignment.
7. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
8. Adjust the rear toe.
Torque: 175 Nm

9. Repeat the rear toe measurement.
10. Align the steering to straight ahead.
11. Adjust the front toe.
Torque: 55 Nm

12. Check, and if necessary, repeat the wheel alignment procedure until the correct values are obtained.
13. Using the Land Rover approved diagnostic system, calibrate the steering angle sensor.
1. Check the geometry specifications.
2. Check the tie rod ends, suspension joints, wheel bearings and wheels and tires for damage, wear and free play.
3. Check and adjust tire pressures.
4. Position the vehicle on a calibrated, level, vehicle lift.
5. Release the vehicle parking brake.
6. Using only four wheel alignment equipment approved by Land Rover, check and adjust the wheel alignment.
7. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
8. Adjust the rear toe.
Torque: 175 Nm
9. Repeat the rear toe measurement.
10. Align the steering to straight ahead.
11. Adjust the front toe.
Torque: 55 Nm
12. Check, and if necessary, repeat the wheel alignment procedure until the correct values are obtained.
13. Using the Land Rover approved diagnostic system, calibrate the steering angle sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
