2009 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE

Body Control Systems: Specifications


Torque Specifications

Battery Junction Box (BJB) Retaining Bolt 10 Nm (7 ft. lbs.)
Battery Positive Cable to Battery Junction Box (BJB) Nut 10 Nm (7 ft. lbs.)
Body Panel Ground Cable Nuts 10 Nm (7 ft. lbs.)
Central Junction Box (CJB) Bracket Retaining Nuts 10 Nm (7 ft. lbs.)

Engine Compartment Ground Cable Nuts:
M6 10 Nm (7 ft. lbs.)
M8 25 Nm (18 ft. lbs.)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.