Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE
Torque Specifications
Torque Specifications
Catalytic Monitor Sensor 45 Nm (33 ft. lbs.)
Catalytic Converter to Exhaust Manifold Bolts* 30 Nm (22 ft. lbs.)
Catalytic Converter to Center Muffler Nut and Retaing Clamps 24 Nm (18 ft. lbs.)
Exhaust Manifold Bolts 24 Nm (18 ft. lbs.)
Exhaust Manifold Heatshield Bolts 10 Nm (7 ft. lbs.)
Exhaust Support Brackets to Front Subframe/Floor Bolts 24 Nm (18 ft. lbs.)
Exhaust Support Bracket to Center Bearing Carrier Bolts 24 Nm (18 ft. lbs.)
Exhaust Tail Pipe Trim Screws 3 Nm (2 ft. lbs.)
Front Muffler Service Sleeve Clamp Nuts 40 Nm (28 ft. lbs.)
Heated Oxygen Sensor (HO2S)** 45 Nm (33 ft. lbs.)
*It is not appropriate to either fit or remove these fixings using air tools due to risk of cold welding/snapping.
**Apply anti-seize lubricants to threads of sensor
-Refer to procedures for correct torque sequences
Catalytic Monitor Sensor 45 Nm (33 ft. lbs.)
Catalytic Converter to Exhaust Manifold Bolts* 30 Nm (22 ft. lbs.)
Catalytic Converter to Center Muffler Nut and Retaing Clamps 24 Nm (18 ft. lbs.)
Exhaust Manifold Bolts 24 Nm (18 ft. lbs.)
Exhaust Manifold Heatshield Bolts 10 Nm (7 ft. lbs.)
Exhaust Support Brackets to Front Subframe/Floor Bolts 24 Nm (18 ft. lbs.)
Exhaust Support Bracket to Center Bearing Carrier Bolts 24 Nm (18 ft. lbs.)
Exhaust Tail Pipe Trim Screws 3 Nm (2 ft. lbs.)
Front Muffler Service Sleeve Clamp Nuts 40 Nm (28 ft. lbs.)
Heated Oxygen Sensor (HO2S)** 45 Nm (33 ft. lbs.)
*It is not appropriate to either fit or remove these fixings using air tools due to risk of cold welding/snapping.
**Apply anti-seize lubricants to threads of sensor
-Refer to procedures for correct torque sequences
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
