Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE
System Specifications
Timing chain tensioner bolt 10 Nm (7 lb-ft)
Timing Cover.
Tighten the bolts in the sequence illustrated.

Torque: M8. 25 Nm
Torque: M7. 16 Nm
Camshaft drive sprocket bolts
Exhaust 75 + 90° Nm (55 + 90° ft.lb.)
Inlet 110 Nm (81 ft.lb.)
Timing Cover.
Tighten the bolts in the sequence illustrated.
Torque: M8. 25 Nm
Torque: M7. 16 Nm
Camshaft drive sprocket bolts
Exhaust 75 + 90° Nm (55 + 90° ft.lb.)
Inlet 110 Nm (81 ft.lb.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
