2008 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE

Intake Manifold

Intake Manifold

Factory service manual diagram



Factory service manual diagram




The intake manifold attaches to the cylinder head with 6 bolts and the oil pan with 2 bolts.

Intake manifold bolts 16 Nm (12 lb-ft)
Lower inlet manifold bolts 10 Nm (7 lb-ft)

Throttle body
Install the throttle body and tighten the screws in the sequence shown.
Torque: 8 Nm (6 lb-ft)

Factory service manual diagram




Throttle body to block support bolt 10 Nm (7 lb-ft)

* New nuts/bolts must be fitted A = refer to procedure for correct torque sequence
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.