Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE
System Specifications
Bore - nominal 84.0 mm (3.307 in)
Main bearing journals:
Number 7
Diameter standard 65 mm + 0.004 - 0.015 mm (2.55 in + 0.000157 - 0.000590 in)
Maximum diameter variation 0.006 mm (0.000236 in)
Big end journals:
Diameter standard 50 mm + 0.004 - 0.015 mm (1.96 in + 0.000157 - 0.000590 in)
Maximum diameter variation 0.01 mm (0.000393 in)
Valves:
Stem diameter - inlet valve 5.97 mm + 0 -.015 mm (0.235 in + 0 -000590 in)
Stem diameter - exhaust valve 5.962 mm +0 -0.007 mm (0.234 in +0 -0.000275 in)
Stem to guide clearance - inlet valve 50-70 in
Stem to guide clearance - exhaust valve 50-70 οΏ½m
Main bearing journals:
Number 7
Diameter standard 65 mm + 0.004 - 0.015 mm (2.55 in + 0.000157 - 0.000590 in)
Maximum diameter variation 0.006 mm (0.000236 in)
Big end journals:
Diameter standard 50 mm + 0.004 - 0.015 mm (1.96 in + 0.000157 - 0.000590 in)
Maximum diameter variation 0.01 mm (0.000393 in)
Valves:
Stem diameter - inlet valve 5.97 mm + 0 -.015 mm (0.235 in + 0 -000590 in)
Stem diameter - exhaust valve 5.962 mm +0 -0.007 mm (0.234 in +0 -0.000275 in)
Stem to guide clearance - inlet valve 50-70 in
Stem to guide clearance - exhaust valve 50-70 οΏ½m
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
