Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE
Pinpoint Tests
Pinpoint Tests
PINPOINT TEST G862000p1 : CHECK SPARK PLUG RESISTANCE
G862000t1 : CHECK SPARK PLUG RESISTANCE
1. Remove the suspect spark plug(s).
2. Measure the resistance between:
^ Is the resistance between 8,000 and 12,000 ohms? (nominal 10,000 ohms)
-> Yes
Check ignition coil and circuits. Refer to the DTC Index for ignition coil and circuit tests.
-> No
INSTALL new spark plug(s). CLEAR the DTC and test the system for normal operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
