Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE
Computers and Control Systems: Technical Service Bulletins
- Recalls
- Customer Interest
- Engine Controls - MIL ON/DTC's P0172/P0175 Set
- Campaign Q029 - CLOSED/Repair Procedure Still Valid
- Engine Controls - Rough Cold Idle/DTCs P050B/P050E/P061A
- Body Controls - Hard Start/Stumbles/MIL ON/DTC's Set
- Body Controls - No Start/Trip Function Resets to Zero
- Engine Controls - No Engine Re-Start When Hot
- By Symptom
- Customer Interest
- Engine Controls - MIL ON/DTC's P0172/P0175 Set
- Campaign Q029 - CLOSED/Repair Procedure Still Valid
- Engine Controls - Rough Cold Idle/DTCs P050B/P050E/P061A
- Body Controls - Hard Start/Stumbles/MIL ON/DTC's Set
- Body Controls - No Start/Trip Function Resets to Zero
- Engine Controls - No Engine Re-Start When Hot
- Driveability
- Recalls
- Starting problems
- Customer Interest
- All Technical Service Bulletins
- Engine Controls - MIL ON/DTC's P0172/P0175 Set
- Campaign Q029 - CLOSED/Repair Procedure Still Valid
- Engine Controls - Rough Cold Idle/DTCs P050B/P050E/P061A
- Recall - Emissions Calibration Update
- Body Controls - Hard Start/Stumbles/MIL ON/DTC's Set
- Body Controls - No Start/Trip Function Resets to Zero
- Engine Controls - Q011 Process Adjustment
- Engine Controls - No Engine Re-Start When Hot
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
