Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE
Mechanical Specifications
Torque Specifications
Camshaft Position (CMP) Sensor Bolt* 10 Nm (7 ft. lbs.)
Catalyst Monitor Sensor 45 Nm (33 ft. lbs.)
Cataylst Monitor Sensor Harness Bolts 6 Nm (5 ft. lbs.)
Crankshaft Position (CKP) Sensor Torx Bolts 10 Nm (7 ft. lbs.)
Engine Control Module (ECM) Bracket Bolts 6 Nm (4 ft. lbs.)
Flywheel Sensor Bolt 10 Nm (7 ft. lbs.)
Flywheel Sensor Bracket Screws 10 Nm (7 ft. lbs.)
Fuel Rail Pressure Sensor 6 Nm (5 ft. lbs.)
Heated Oxygen Sensor (HO2S)** 45 Nm (33 ft. lbs.)
Knock Sensor Retaining Bolt 20 Nm (14 ft. lbs.)
Mass Air Flow (MAF) Sensor Torx Screws 2 Nm (1 ft. lbs.)
*Apply CLEAN engine oil to a new CMP Sensor O-ring
**Apply anti-seize lubricant to threads of sensor
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
