2008 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE

Engine Control Module: Service and Repair



Engine Control Module (ECM)

Service Repair No - 18.30.03


Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Remove the cover and disconnect the battery ground cable.
2. Remove the plenum chamber panel.

Factory service manual diagram




4. Petrol ECM shown, diesel similar.

Factory service manual diagram




5. Torque: 6 Nm

Factory service manual diagram




Installation
1. To install, reverse the removal procedure.
2. If a new component has been installed, configure using Land Rover approved diagnostic equipment.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.