Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE
Engine Oil: Service and Repair
Engine Oil Draining and Filling
Service Repair No - 12.60.05
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the oil filter.
3. Remove the engine undershield.
4. WARNING: Avoid skin contact with the specified material.
CAUTION: Hot fluid.
CAUTION: Be prepared to collect escaping fluids.
Torque:
38 Nm
Remove and discard the sealing washer.

5. CAUTION: Make sure that the component is clean, free of foreign material and lubricant.
CAUTION: Make sure that new sealing washers are installed.
To install, reverse the removal procedure.
6. Check and top-up the engine oil.
Service Repair No - 12.60.05
NOTE: Removal steps in this procedure may contain installation details.
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Remove the oil filter.
3. Remove the engine undershield.
4. WARNING: Avoid skin contact with the specified material.
CAUTION: Hot fluid.
CAUTION: Be prepared to collect escaping fluids.
Torque:
38 Nm
Remove and discard the sealing washer.
5. CAUTION: Make sure that the component is clean, free of foreign material and lubricant.
CAUTION: Make sure that new sealing washers are installed.
To install, reverse the removal procedure.
6. Check and top-up the engine oil.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
