2008 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE

Steering Geometry (Wheel Alignment)

Steering Geometry

Front

Camber -0.50°+/-0.75° (-0.30'+/-0.45')
Total/Balance 0.0°+/-0.75° (0'+/-0.45')

Castor 3.25°+/-0.75° (3°15'+/-0.45')
Total/Balance 0.0°+/-0.75° (0'+/-0.45')

Total Toe 0.20°+/-0.20° (0.12'+/-0.12')


Rear

Camber 1.95°+/-0.75° (-1°57'+/-0.45')

Toe 0.17°+/-0.14° (0.10'+/-0.8')
Total 0.33°+/-0.20° (0.10'+/-0.8')

Thrust Angle 0.0°+/-0.14° (0.0'+/-0.8')

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.