Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Land Rover LR2 (LF) L6-3.2LFACTORY OEM SERVICE PROCEDURE
Navigation Module: Service and Repair
Navigation System Digital Versatile Disc (DVD) Unit
Removal
NOTE: Removal steps in this procedure may contain installation details.
1. Torque: 6 Nm
2. CAUTION:
^ Make sure that the fiber optic cables are not bent to a radius of less than 25 mm.
^ Make sure that the optical connectors are clean and free of foreign material.
Installation
1. To install, reverse the removal procedure.
2. If a new component is to be installed, configure using Land Rover approved diagnostic equipment.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
