2007 Land Rover Range Rover Sport HSEFACTORY OEM SERVICE PROCEDURE

Quick Lookups: Fluids

FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil 4.40 OZS. 0.13 L PAG 46 S
Air Cond Refrigerant Front & Rear 2.00 LBS. 0.9 KG R-134a For further details see "Air conditioner specification label". S
Air Cond Refrigerant Front 1.35 LBS. 0.61 KG R-134a For further details see "Air conditioner specification label". S
Automatic Transmission Fluid Dry Fill 10.00 QTS. 9.46 L SHELL M13754 Land Rover Part No. TYK5000050. A final fluid level check/top-up must be carried out when the unit has been installed. S
Brake Fluid N/A N/A SHELL DONAX YB DOT4 ESL Fluid S
Differential Gear Oil Front 1.07 PTS. 0.5 L CASTROL SAF-XO- 75W-90 S
Differential Gear Oil Rear,Electronic Torque Managed (ETM) Differential 3.17 PTS. 1.49 L CASTROL SAF Carbon Mod Plus S
Differential Gear Oil Rear,Open Unit 2.30 PTS. 1.08 L CASTROL SAF-XO- 75W-90 S
Engine Coolant 4.4L Eng 10.05 QTS. 9.51 L TEXACO Extended Life Coolant (XLC) or any Glycol Based Antifreeze containing no methanol with only Organic Acid Technology (OAT) corrosion inhibitors S
Engine Oil Drain and Refill,w/Filter 8.10 QTS. 7.66 L SAE 5W-30 (Preferred): WSS-M2C913-B, (Alternative): ACEA A3/B3 S
Fuel Tank 23.20 GALS. 87.82 L S
Power Steering Fluid 3.20 PTS. 1.51 L TEXACO Cold Climate Fluid 33270 S
Transfer Case Fluid 1.50 QTS. 1.41 L SHELL TF 0753 S
Windshield Washer Fluid N/A N/A Windshield Washer Fluid Follow the Manufacturer's Instructions for the mixture ratio. S
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.